OTR-1/OTR-2 Infrared Transmitter
OR-1 Infrared Receiver Headset
asˇsis´tive (e-sīst´) v. to help: aid.
Home | Cinema Products | Fiber Optic Products | Solar Products |
News & Updates |
Tech Notes | About Odyssey
Contact Us
|
|
OTR-1/OTR-2 Infrared Transmitter OR-1 Infrared Receiver Headset asˇsis´tive (e-sīst´) v. to help: aid. |
|
|
|
Assitive Listening Systems
| The Large Area System covers a room approximately 125' Deep x 75' Wide, and up to 10' beneath and behind emitter panels. This system includes all of the following equipment: (Model OR-1 Sold Separately) | ||||
| 1 | Model OTR-1 Transmitter |
 |
|
|
| 1 | 24V 1.67 Amp UL and CSA Power Supply | |||
| 2 | Model OEP-1 Emitter Panels with Mounting Hardware | |||
| 60' | RG Hookup Cable | |||
| 1 | Installation and Operation Manual | |||
|
Model OIS Large Area Infrared System Price: $870.00 |
||
|
|
||
Model EC-1 Economy Infrared System
| The Economy System covers a room approximately 100' Deep x 45' Wide, and up to 10' beneath and behind emitter panel. This system includes all of the following equipment: (Model OR-1 Sold Separately) | ||||
| 1 | Model OTR-2 Transmitter |
 |
|
|
| 1 | 24V 1.67 Amp UL and CSA Power Supply | |||
| 1 | Model OEP-1 Emitter Panel with Mounting Hardware | |||
| 30' | RG Hookup Cable | |||
| 1 | Installation and Operation Manual | |||
|
Model EC-1 Economy Infrared System Price: $645.00 |
||
Model OTR-1 Dual Output / OTR-2 Single Output
Infrared Transmitter
| accessories | manual | |||
Input is taken directly from the output of the sound system. No B chain noise is introduced into the system which would mask and limit signal. Odyssey uses a flat bandpass response of 250Hz to 7Hz, +/- 1dB with a 12dB per octave roll off at 250Hz and 7KHz. This tailors the signal from the processor specifically for the hard of hearing. |
 |
||
| Model OTR-1 Dual Output Transmitter: $515.00 | |||
|
|
|||
| Model OTR-2 Single Output Transmitter: $435.00 | |||
Technical Specifications
| Power | 110V / 120 Volts AC |
| Frequency Response | 250Hz to 7KHz |
| Carrier Frequency | 95KHz |
| Input Sensitivity | From 100MV to 6 volts RMS-20 Ohm unbalanced |
| Input Connector | Terminal Strip LCR from Processor |
| Output Connector | Terminal Strip |
Features
| ˇ Single Space 19' Rack Mount Chassis |
| ˇ Uses a Level Guard Circuit to prevent over-modulation |
| accessories | manual | |||
Emitters are installed at the rear of the auditorium, thus saving on long runs of wire With visual LED indicators, personnel know the system is working. |
 |
||
| Model OEP-1 Infrared Emitter Panel Price: $ 230.00 | |||
Features
| ˇ LED's on the emitter panel indicate all diodes are operational |
Technical Specifications
| Connection to Transmitter | Fanning strip, RG Cable-Plenum cable available |
| Diode Configuration | 50 Infrared Diodes / 5 Power indicator diodes |
| Coverage Area (Uniform) | Front of Emitter - Rectangular, Rear of Emitter - Spherical |
Model OR-1 Infrared Receiver Headset
| accessories | manual | |||
The receiver may be used in any auditorium without the confusion of dialing to the right frequency. Box office or concession employees will not be distracted from their duties to make the decision of which receiver to hand out for the correct auditorium. |
|
||
| Model OR-1 Infrared Receiver Price $105.00 | |||
Features
| ˇ Two receivers in one: Built-in magnetic windings in each ear-piece works as a powerful loop for use with Telecoil. High quality speakers in each ear-piece provide a strong clear signal. Works well with in-the-ear type hearing aids. |
| ˇ Comfortable design: The large ear-pieces cover both the ear and hearing aid. Ear-pieces slide up and down the headband for a better fit, and swivel from side to side to accommodate behind-the-ear aids. |
| ˇ Headband cushion: Padded, for comfort over an extended time. Removable Velcro cushions. |
| ˇ Volume control: Allows the sound to be set at a comfortable level. A maximum output of 110dB, allows adequate hearing for all types of hearing loss, and will not cause additional hearing loss by exposing the user to damaging levels of sound. |
| ˇ Low power LED on the receiver tells personnel to change the battery. |
| ˇ Works on standard 95KHz frequency for compatibility. |
Technical Specifications
| Frequency Response | 250Hz to 7KHz with roll-off filters |
| Max SPL Complex Wave Form | 110dB |
| Power | 9 Volt Alkaline or Rechargeable |
| Operation Time | 40 to 80 Hours |
|
