 |
FIBER OPTIC PRODUCTS Fiberlink Fiber Optic Status System Fiber Optic Cable and Accessories
fi·ber-op·tic (fėīber-opītic) adj. the optics of light transmission through very fine, flexible glass rods by internal reflection. |
|
|
| The "Fiberlink" Fiber Optic Status System works with any automation or combination of automations in one booth. The easy to install system is a sixteen screen status panel with eight status blocks per screen. Additional panels are available in eight screen increments, with a maximum of thirty-two screens. Information is sent to the status panel through the Automation Interconnect via fiber optic cable. Each Automation Interconnect unit has its own address. |
|
Features
| · Fiber optic cable is not affected by electromagnetic interference such as xenon igniter, arcing switches or long runs of cable. |
| · Display of up to thirty-two screens is possible with the system - distance is not a factor. |
| · One fiber optic cable replaces multiple pairs of conventional wire. Fiber optic cable is also available in plenum. |
| · Adding screens to an existing theatre complex is more cost effective - just daisy chain the panels together. |
| · Main panel accommodates 16 screens - additional panels in 8 screen increments. |
| · Eight bit status per screen · Four set statuses - Film Break, Que, Run, Intermission · Four custom statuses screened on each panel - Example: Exhaust Fan, Analog/Digital, Flat/Scope, House Lights Up/Down |
| · Automation Interconnect works with any automation - mounts in the console or on the wall next to the automation. |
| · Easy to install - 8 hook-up points |
| · All automation interfaces are addressed through DIP switches at each projector. |
| · Inexpensive fiber optic cable tester available to test continuity of cable. |
Technical Specifications
| Status Panel | Automation Interconnect |
| · Power: 120V/12.6 VAC 1 amp power pack | · Power: 120V/12.6VAC 1 amp power pack |
| · Status Refresher Rate: 250 milliseconds | · Fiber Optic Connector: ST |
| · Transmission Method: digital fiber optic | · Automation Interface: opto isolators, high or low programmable 1000V isolation |
| · Transmission Wavelength: 920 nanometers (near infrared) | |
| · Fiber Optic Cable: plastic or 63.5nm glass | |
| · Fiber Optic Connector: ST | |
| · Fiber Optic Transmitter/Receiver: Hewlett Packard | |
| · Maximum Operating Range: 3.5 kilometers between panels |
| Model FSP | Fiber Optic 16 Screen Status Panel | Call for quote |
| Model FI-1 | Fiber Optic Interconnect Box (Specify one FI-1 per automation) | Call for quote |
| Model FSS-8 | Fiber Optic 8 Screen Slave Panel | Call for quote |
Fiber Optic Cable and Accessories
Cables can be ordered in standard lengths with connectors already attached and polished. Cable and connectors can also be ordered individually and made up in the field with a connector.
| Model SFC | Single Fiber Optic Cable | Call for quote |
| Model SFC-Pl | Plenum Single Fiber Optic Cable | Call for quote |
| Model DFC | Duplex Fiber Optic Cable | Call for quote |
| Model DFC-Pl | Plenum Duplex Fiber Optic Cable | Call for quote |
| Model TCST | Fiber Optic ST Connector | Call for quote |
| Model CF20 | Twenty foot length fiber cable with connectors | Call for quote |
| Model CF30 | Thirty foot length fiber cable with connectors | Call for quote |
| Model FT-3 | Fiber connector kit | Call for quote |
