 |
Equipment for Upgrade
up·grade (üp´gräd´) v. to increase the rank, grade, or standard of |
|
|
|
| manual | |||
The Odyssey QE-3 Automation Cue Expander Board is an upgrade for older automations. It allows the same film cue to be repeated for sequences up to 3 events. The Cue Expander can be used with 'ANY' automation. |
|
||
|
Model QE-3 Cue Expander Price: $193.00 |
|||
|
|
|||
Features
| · Three programming (event) cues such as house lights up/down, lens change, or sound formats |
| · The card 'power', 'set' and 'cue' inputs can be from different voltage sources. |
| · Mounts in any convenient location. (Mounting hardware included). |
| · Sequences three cues from older automations with only one cue. |
| · The third cue can be disabled if not needed. |
| · Output relay contacts rated at 110 volt 1A |
| · Card can be set with pulse or latch |
| · Works with any spare cue detector |
Technical Specifications
| Dimensions | 3-1/2" Height x 5-1/4" Width x 1" Depth |
| Weight | 1 pound |
| Terminations | Compression Terminal |
Mid level add-on circuit for Xetrol Automations The XMC-1 is a add-on control board for the Xetrol IV Light Dimmer. It adds a both mid-up and mid-down levels, which can be used for half houselights during trailers and end credits. The XMC-1 card is installed into the Xetorl dimmer, without any need to modify the existing circuitry in the dimmer. |
|
||
|
Model
XMC-1 Add-on
Circuit for Xetrol automation |
|||
|
|
|
||
The ELS Exciter LED Switching System extends the life of your Analog Exciter LED's by automatically switching them off when they are not needed. |
Model
ELS Exciter LED
Switching System |
||
|
|
|||
| · The ELS system monitors the status of the sound processor in the sound rack, and switches the Exciter LEDs OFF during digital playback, and during intermission. |
| · The ELS switches the Exciter LEDs ON when an analog sound format (Mono, Type A, and Stereo SR) is selected, and when a Digital playback defaults to Analog fallback. |
| System Includes |
|
The ELS system requires two cards for each sound system: |
| · The Model ELS-R is a relay board installed in the automation to switch the LEDs. This board is standard with ELS systems of all processor types. |
| · The Model ELS-P is a processor specific board installed on the back of the processor* which sends control signals to the ELS-R board. |
| *Board may not install on back of some older processors |
